-40%
1.8A SXD Super X-Drive Laser Driver M140 - PLTB450B - NDB7875 - NDG7475

1.8A SXD Super X-Drive Laser Driver M140 - PLTB450B - NDB7875 - NDG7475

$ 15.83

Availability: 66 in stock
  • All returns accepted: Returns Accepted
  • Brand: DTR's Laser Shop
  • Item must be returned within: 30 Days
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Country/Region of Manufacture: United States
  • MPN: Does Not Apply
  • Return shipping will be paid by: Seller
  • Condition: New
  • Restocking Fee: 10%

    Description

    Listing is for a single 1.8A SXD Super X-Drive Bucking Laser Driver. The X-Drive is an extremely efficient buck style regulator with many built in safety features to protect and give long life to your laser diodes.
    Driver has soft start, overshoot protection and very low noise as well as self bleeding output caps to prevent spikes by charged output caps that so many diodes have been lost to from other drivers. This version of the driver is suited to work with the M140, NDG7875, NDB7675, NDG700, NDG7475, NUGM01 or the PLTB450B laser diodes using a 7-12V power source capable of 2A+ like two Li-ions in series. Input and output pads are clearly marked for easy installation.
    Here are a some pictures of the dimensions:
    SXD Super X-Drive TTL control. These instructions are only if you plan to use TTL to control the driver. If you don't plan on using TTL the driver will work as is no need to modify anything.:)
    PWN/TTL
    Modulation Frequency: Up to 1kHz
    Modulation Voltage 0-5V Full range: 1.6V ON "Max 12V" & 0.6V - 0V OFF
    Solder the modulation Wire to the Yellow Arrow after removing the 10K.^^^^
    Like SO:
    Enable Pin is High "ON" Minimum 1.6V with an Ultimate MAX of 12V input
    Enable Pin is Low "OFF"  0.6V or lower
    12V MAX the enable pin can take.
    Remove the Ramp Up Capacitor.